Panasonic AJ-PX800G, Руководство по эксплуатации

Страница: 93 / 220

– 93 –
Chapter 4 Shooting — Setting the time data
t
After executing slave once, even if input from the <TC IN/OUT> terminal stops, the slave status will continue. However, in the following cases, the
slave status of the user bits will be released.
- When [UBG MODE] is set to other than [EXT]
- When user bits are set in the [SET01:TC/UB] screen of SmartUI
- When the power is turned off
t
The internal [USER] value retains the slaved value even after slave lock is released.
t
To input external time codes from the <TC IN/OUT> terminal, set [TC IN] in the main menu → [IN/OUT SEL] → [TC IN/OUT SEL].
How to input user bits
By setting user bits, information such as memos (date, time) up to eight digits long (hexadecimal) can be recorded.
HOLD COUNTER RESET MONITOR SEL
/REW STOP FF/ PLAY/PAUSE
CAM
AUDIO
SET UP
HOME
LIGHT
0
-10
-18
-20
-30
dB
TC NDF SLABE P -REC
1 2
MEDIA
E F
BATT
E F
CH1
CH2
A
a b
c
d
a: <HOLD> button
b: <COUNTER> button
c: <SETUP> button
d: <HOME> button
1
Press the <SETUP> button to display the [SET01:TC/UB] screen of SmartUI.
2
Press the <COUNTER> button to set the counter display to [UB].
3
Press the <
%
/REW> button to set [UBG] to [SET].
4
Set the user bits.
f
Press the upper or lower buttons that correspond to the following screen displays.
- [
→ ]: The digit to be set moves to the right.
- [ + ]: The digit to be set moves to the left.
- [ − ]: The value of the digit to be set is incremented by one.
- [RST]: The value of the digit to be set is decremented by one.
5
Press the <
%
/REW> button, enter the values of user bits, and exit the user bits settings screen.
6
Select [USER] in the main menu → [RECORDING SETUP] → [UBG MODE].
@ @ NOTE
t
If you exit the user bits setting screen without pressing the <
%
/REW> button, the set values are disabled.
Retention of user bits in memory
User bit settings are automatically recorded and are retained even if the power is turned off.