Orientalmotor aSTEP AZ Series, Руководство пользователя, Страница: 177 / 180

Regulations and standards
177
7 R
ef
er
enc
e ma
ter
ials
3 Regulations and standards
3-1 UL Standards, CSA Standards
This product is recognized by UL under the UL and CSA Standards.
Check the APPENDIX UL Standards for
AZ Series for recognition information about UL Standards.
3-2 CE Marking/UKCA Marking
EU Declaration of Conformity can be downloaded from Download Page of the product in Oriental Motor Website
(https://www.orientalmotor.eu/).
„
AC power input driver
This product is affixed with the marks under the following directives/regulations.
z
EU Low Voltage Directive/UK Electrical Equipment (Safety) Regulation
Installation conditions
Overvoltage category II
Pollution degree 2
Degree of protection IP20
Protection against
electric shock
Class I Equipment
•
This product cannot be used in IT power distribution systems.
• To protect against electric shock using an earth leakage breaker (RCD), connect a type B earth leakage breaker to
the power supply side of the driver.
• Use a molded case circuit breaker (MCCB) that conforms to EN standards or IEC Standards.
•
Isolate the motor cable, the power supply cable and other drive cables from the signal cables by means of double
insulation.
•
The temperature of the driver's heat sink may exceed 90 °C (194 °F) depending on the driving condition. Observe
the followings.
· Be sure to perform a test operation and check the driver temperature.
· Do not use the driver near combustibles.
· Do not touch the driver while operating.
z
EU EMC Directive/UK EMC Regulation
Refer to “4-9 Conformity to the EMC” on p.37 for details about conformity.
z
EU Machinery Directive/UK Machinery Regulation
Applicable standards: EN ISO 12100, EN 61800-5-2, EN ISO 13849-1: 2015
„
DC power input driver
This product is affixed with the marks under the following directives/regulations.
z
EU EMC Directive/UK EMC Regulation
Refer to “4-9 Conformity to the EMC” on p.74 for details about conformity.