looking from the inside of the chassis, the part of the metal to the left of the ports
continues straight and is attached to the inside of the rear panel. To the right of the
ports, the metal bends 90 degrees towards the rear of the chassis, and is inserted
through the rear panel.
2.
Remove the screw on the outside of the chassis that holds the module seated
against the rear panel of the chassis.
3.
Grasp the module by its edges. Pull the right side of the module out of the rear
panel slot, and, at the same time, slide the left side of the piece of metal from the
rear panel.
4.
Pull the module laterally out of the plug and away from the rear panel of the
chassis. You may have to work the module back and forth as you pull, in order to
disengage the module from the two directions.
Note that there is a gap in the edge connector of the module PCB. There are
metal bands on either side of the gap. The left-most part of the connector section
is outside of the plug.
Chapter 5
Maintenance Without Power
5-20
