42
2-6-2 Wiring
Only use a shielded RS-232C cable. The maximum cable length is 15 m.
Standard Wiring
Wiring for RS/CS Control
Note
Pin numbers on the external device will depend on the device being connected.
Refer to the manual for the personal computer or PLC being connected.
2-6-3 Connection
Align the connector with the socket and press the connector straight into place.
Tighten the two screws on the edges of the connector.
Notice
- Always turn OFF the power supply before connecting or disconnecting
cables. The peripheral device may be damaged if connected or discon-
nected with the power supply turned ON.
- Always tighten the connector screws.
Pin No.
Z300
Signal
SD(TXD)
RD(RXD)
RS(RTS)
CS(CTS)
SG(GND)
2
3
4
5
9
Pin No.
External device
Signal
SD(TXD)
RD(RXD)
RS(RTS)
CS(CTS)
SG(GND)
∗
∗
∗
∗
∗
Shield
Pin No.
Signal
SD(TXD)
RD(RXD)
RS(RTS)
CS(CTS)
SG(GND)
2
3
4
5
9
Pin No.
External device
Signal
SD(TXD)
RD(RXD)
RS(RTS)
CS(CTS)
SG(GND)
∗
∗
∗
∗
∗
Shield
Z300
RS-232C Wiring
Section 2-6
Содержание Z300 V3 - SETUP
