Communications Command
Section 5-3
5-16
5-3-5 Polling Single Auto Read (PR)
Immediately after receiving the Polling Single Auto Read Command, the Reader/Writer returns a re-
sponse indicating the acceptance of the command, and waits for a Tag to enter the communications
area of the Antenna. Then it reads the data of the entering Tag. The host can inquire of the
Reader/Writer about the results of communications processing using the Polling Check (PC) com-
mand.
<Command Format>
STX
Node No..
Command code
“PR”
Data
type
Tag
type
First read
page
No. of read
pages
ETX BCC
1 2
2 1
1 2 2 1
1
Data type
Specifies whether the read data is represented in ASCII or HEX.
A : ASCII code
H : HEX code
*For details, refer to 5-9 Data Type
Tag
type
In ISO mode
Specify the Tag type.
A: I.CODE2 chip
*
In I.CODE1
mode
Not added
First read page
Specifies the first page in hexadecimal to read data from the Tags.
Specification range: 00 to FFh
(In ISO mode: I.CODE2 chip should
be from 00 to 1Bh)
Specification range: FB to 0Ah
(In I.CODE1 mode)
* For details, refer to 2-4 Memory Map of Tag.
No. of read pages
Specifies the number of the pages in hexadecimal to read data from the
Tags.
Specification range: 01 to FFh
(In ISO mode: I.CODE2 chip should
be from 01 to 1Ch)
Specification range: 01 to 10h
(In I.CODE1 mode)
* Tag Type Setting is valid in the operating mode setting range of Reader/Writer.
<Response Format>
STX Node
No.. Retry
flag
Command code
“PR”
Response
code
“74”
ETX BCC
1 2 1 2
2 1
1
Response code
74: Command acceptance
For other response codes, refer to 5-2-4 Response code List.
Содержание V720S Series
