Omron V720S Series, Руководство по эксплуатации

Страница: 35 / 142

Memory Check Function I.CODE1 Mode Only Section 3-2
3-4
3-2 Memory Check Function I.CODE1 Mode Only
By adding a check code to the data in the Tag, you can detect data errors due
to the Tag memory (EEPROM) being overwritten, service life, and unforeseen
factors.
The check code uses the CRC code of the generating polynomial X16 + X12
+ X5 + 1.
A memory check is performed using the Memory Check Command (MC),
which writes the check code, and the Memory Calculation Command (MK),
which verifies the check code. In the check block defined using the header
page and the number of pages, the target calculation area is the area except
for the last page of the block, and the last page is the check code area. The
check code uses two bytes in the check code area.
When a check code write command is sent, the CRC code for the data in the
target calculation area is calculated, and written to the check code area.
When the data verification command is sent, the CRC code for the data in the
target calculation area is calculated, and compared with the data in the check
code area. If these match, the number 75 is returned in the response code to
show that the data is normal. If they do not match, the number 76 is returned
to show that there is a data error.
Example: Memory check is performed when check block header page is 00
and the number of check blocks is 0B.
00
01
・
・
・
09
0A
3-2-1 Usage
After writing the data, calculate and write the check code using the Memory
Check Command (MC), and before reading the data, verify the check code
using the Memory Calculation Command (MK). You can detect data
corruption in advance within the Tags that are not being accessed.
Write data
Write stage
Calculate check code
Verify check code
Read stage
Read data
Note
•
This Command is for I.CODE1 Mode Only.
The command is not available in ISO mode:
Check code area
Check code
Calculation area