Wiring Method
Section 4-4
4-14
4-4-3 Assembly of Connector
4-4-3-1 Assembly of Host Communications Connector and I/O Connector
1) Disassemble the connector as follows:
a) Loosen the set screws and remove the barrel from the end bell (by
turning it counterclockwise).
b) Loosen Set Screw B, remove the clamp nut from the end bell, and pull
out the washer and the cable packing.
2) Draw the cable through the disassembled parts in the order shown below.
・
Make sure that the parts are in the correct order and orientation.
3) Strip a part of the sheath and insulator of each cable to be used according
to the measurements specified in the table below.
•
Cable terminal treatment measurement table
Usage
Connector name
Mesure-
ment A
(mm)
Mesure-
ment B
(mm)
Conductor
cross-sec-
tional area
(mm
2
)
Iron tip
tempera-
ture(%)
Host communica-
tions/IO
NJW-165 + PF, PM, A
d
F
16 280
Power supply
NJW-2010 + PF, PM, A
d
F 18
3.2 0.5
350
4) Pre-solder the conductors complete with terminal treatment.
Note
•
Be careful not to pre-solder the cable cladding.
•
When finished, the pre-soldered part should be smaller in diameter than the
contact hole and have no uneven portion on the entire surface.
Clamp nut
Cable packing
End bell
Coupling nut
Barrel
Set screw B
Washer
Set screw A
Clamp nut
Cable packing
End bell
Coupling nut
Set screw B
Washer
Set screw A
Cable
Conductor envelope
Envelope
Содержание V720S Series
