Reader/Writer Setting
Section 4-1
4-2
4-1 Reader/Writer
Setting
The Reader/Writer has been designed for the user to make all the settings by
issuing commands from the host. The user can use either the COM1 or
COM2 port to make settings. However, we recommend use of the COM2 port
because its communications settings have been fixed at factory to survive a
power reset.
In order to fix the information set for the Reader/Writer to survive a power
reset, it is necessary for the user to execute the setting write command (EW)
(refer to 10) in 5-2-14 of Section 5). (This does not apply to the communica-
tions settings for the COM2 port).
4-1-1 Host Communications Setting (COM Port Setting)
Make settings for host communications by using the communications port
setting command (CP) (refer to No. 3 in 5-6-14 of Section 5).
Setting name
(command name)
Port
Default
set value
Setting
range
Description
COM1 38400
bps
Baud rate setting *1
(CP command)
COM2 9600
bps
9600 bps
19200 bps
38400 bps
115200 bps
This command sets the baud rate for use in
communications with the host.
COM1 7bits
Data length setting *1
(CP command)
COM2 7
bits
7 bits
8 bits
This command sets the data length for use in
communications with the host.
COM1 Even
Parity bit setting *1
(CP command)
COM2 Even
None
Odd
Even
This command sets the parity bit for use in
communications with the host.
COM1 2bits
Stop bit setting *1
(CP command)
COM2 2
bits
1bit,
2 bits
This command sets the stop bit for use in
communications with the host.
COM1 Enabled
BCC bit setting *1
(CP command)
COM2 Enabled
Disabled
Enabled
This command sets whether the BCC for
command frames and response frames for
communications with the host will be en-
abled or disabled. Using the BCC is referred
to as "BCC enabled."
COM1 No
ACK/NACK setting *1
(CP command)
COM2 No
No
Yes
This command sets whether or not
ACK/NACK control is performed between
the host and the Reader/Writer. If this control
is not performed, it is referred to as "no
ACK/NACK control."
COM1 5
sec.
Timeout setting *1
(CP command)
COM2 5
sec.
0.5 sec.
5 sec.
This command sets the timeout period for
ACK/NACK control. This setting will be
meaningless unless this command
(ACK/NACK control) is set to ON.
Note
(*1) The communications settings for the COM2 port can also be changed but
will return to the Default set values on resetting the power of the
Reader/Writer.
Содержание V720S Series
