Omron CVM1-CLK21, Руководство по эксплуатации

Страница: 40 / 309

24
Message Service Procedure Section 2-2
AR 0704 (operating level #1)
CVM1/CV Series: Word 0 of DM 2000 + 100
×
N
CQM1H Series: AR 0700
8. Stop the data links.
Note Data link Start/Stop Bit (N= unit number):
CS/CJ Series: Word 0 of D 100
×
N
C200HX/HG/HE: AR 0700 (operating level #0),
AR 0704 (operating level #1)
CVM1/CV Series: Word 0 of DM 2000 + 100
×
N
CQM1H Series: AR 0700
Note The data links will not start if there is an error in the data link tables
in the startup node. Data links can be started and stopped using the
Controller Link Support Software.
2-2 Message Service Procedure
The following steps outline the basic procedure for using the message ser-
vice.
1,2,3... 1. Install and wire the Units.
2. Prepare for communications.
3. Turn ON the power to the PC.
4. Create the I/O tables.
Contents Method Nodes Page
Stop the data links. Switch the Data link
Start/Stop Bit (listed
below) from OFF to
ON using either the
Programming Device,
or the user program. Any node that is active
in the data link 100
Contents Remarks Page
a. Mount the Units to the PCs.
--- 40
b. Wire the Network.
--- 44
Contents Remarks Page
a. Set the unit number.
CS/CJ-series, CVM1, and CV-
series PCs only 62
b. Set the node address.
--- 59, 62
c. Set the baud rate.
--- 59, 63
d. Set the operating level.
C200HX/HG/HE PCs only 59
e. Set the terminal resistance.
--- 60, 63
Contents Remarks Page
Turn ON the power to the PC. --- ---
Contents Remarks Page
Create the I/O tables. CS/CJ-series, CVM1, and CV-
series PCs only ---