Omron CVM1-CLK21, Руководство по эксплуатации

Страница: 238 / 309

222
Troubleshooting Using Indicators Section 9-1
9-1-2 C200HX/HG/HE and CQM1H-series Controller Link Units
Troubleshooting with RUN, ERC, ERH and INS Indicators
The RUN, ERC, ERH, and INS indicators can be used to check whether Con-
troller Link Unit startup and Network participation are operating normally.
Note Be sure to turn off the power to the PC before performing any of the following.
• Disconnecting the Unit or connectors.
• Securing Units or connectors.
• Setting hardware switches.
RUN: Operating
ERC: Communications
error
INS: Network participation
LNK: Data link
M/A: Data link mode
TER: Terminating resistance set
RUN
ERC
INS
SD
RD
M/A
LNK
TER
ERH
CLK21
CQM1H-series Unit C200HX/HG/HE Unit
RUN
ERC
INS
SD
RD
M/A
LNK
TER
ERH
CLK21
Indicators Probable cause Probable remedy
RUN ERC ERH INS
Lit Not lit Not lit Lit Unit operating normally;
Network participation nor-
mal. ---
Not lit Lit --- --- Controller Link Unit faulty. If the ERC indicators still
lights when the Unit is
mounted on another PC,
replace the Controller Link
Unit.
Not lit Not lit Not lit Not lit Power is not being sup-
plied correctly to the PC.
Check the power supply
voltage and supply at the
recommended voltage.
The Controller Link Unit
has become loose. Secure the Controller Link
Unit firmly.
The Bus Connection Unit
has become loose. Tighten the mounting
screws on the Bus Con-
nection Unit.
The Controller Link Unit is
mounted in the wrong slot. Refer to 3-2-1 C200HX/
HG/HE PCs and 3-2-4 CJ-
series PCs and mount the
Unit correctly.
The Controller Link Unit is
faulty. If the indicators do not light
when the Unit is mounted
on another PC, replace the
Controller Link Unit.
Lit Lit --- Not lit The node address is out-
side the setting range.
Reset the node address to
within the 1 to 32 range.
The same node address is
being used by two different
Units. Reset so that each node
address is used only once
within the same Network.