Omron CVM1-CLK21, Руководство по эксплуатации

Страница: 221 / 309

205
Data Link I/O Response Time Section 8-3
3. The data transferred in data link processing arrives at the PC at node #7
while data exchange is taking place, so the data will not be read into the
PC until the next data exchange, causing a delay of up to one cycle.
The maximum number of words that can be exchanged in a single data ex-
change is approx. 7,800 words for CS/CJ-series PCs, approx. 3,700 words
for CVM1 and CV-series PCs, approx. 4,000 for C200HX/HG/HE PCs, and
approx. 1,200 words for CQM1H-series PCs.
The equation for maximum data link I/O response time is as follows:
Note If the total number of data link words is greater than the maximum number of
words that can be exchanged per data exchange, the maximum data link I/O
response time will be cycle time of PC at node #7
×
3.
In case of the CQM1H, however, the cycle time will be incremented by the
value obtained from dividing the total number of data link words by the maxi-
mum number of words (1,200 words) per time.
For example, if the total number of data link words is 5,000, the result will be
as shown below.
5,000/1,200 = 2.5 (approx. 3)
Cycle time of PC at node #7
×
(2+3)
Noise may increase I/O delays.
Minimum Response Time
Input ON delay 1.5 ms
Cycle time of PC at node #1
×
2 8 ms
×
2
Communications cycle time
×
4 9.9 ms
×
4
PC cycle time at node #7
×
2 (see note) 8 ms
×
2 (see note)
Output ON delay 15 ms
Total (data link I/O response time) 88.1 ms
Input device
Program
Program
Input
Input ON delay
1 cycle
Output
Output device
Output ON
delay
1 cycle
Data link transmission
Controller Link Unit
transmission processing
PC at node #7
PC at node #1
Communications
cycle time
Data link I/O response time
I/O refresh
Data exchange