Omron CVM1-CLK21, Руководство по эксплуатации

Страница: 36 / 309

20
Data Links Procedures Section 2-1
2-1 Data Links Procedures
2-1-1 Manually Setting Data Links
When the data link mode is set for manual data link table creation, the data
link tables can be input using the Controller Link Support Software or CX-Pro-
grammer. Use the following procedure.
1,2,3... 1. Install and wire the Units.
2. Prepare for communications.
3. Turn ON the power to the PC.
4. Connect the Programming Device.
5. Create I/O tables.
Contents Method Nodes Page
a. Mount the Units to
the PCs.
--- All nodes 40
b. Wire the Network.
--- All nodes 44
Contents Method Nodes Page
a. Set the unit num-
ber.
Use the front rotary
switches. CS/CJ-series, CVM1,
and CV-series PCs
only 62
b. Set the node
address.
Use the front rotary
switches. All nodes 59,62
c. Set the baud rate.
Use the DIP switch. All nodes 59, 63
d. Set the operating
level.
Use the DIP switch. C200HX/HG/HE PCs
only 59
e. Set the terminal
resistance
Use the front switch
for CVM1, CV-series,
CS/CJ-series, and
CQM1H-series PCs or
the bottom switch for
C200HX/HG/HE PCs
.
All nodes
End nodes on the net-
work: ON
All other nodes: OFF
60, 63
Contents Method Nodes Page
Turn ON the power to
the PC. --- All nodes ---
Contents Method Nodes Page
Connect the Program-
ming Console or Con-
troller Link Support
Software. Use the special con-
nection cable. CS/CJ-series, CVM1,
and CV-series PCs 10
Contents Method Nodes Page
Input the I/O tables. Use the SYSMAC
Support Software or
Programming Con-
sole. CS/CJ-series, CVM1,
and CV-series PCs
only ---