As mentioned above,
Datalog X-PRO user can connect up to three different sensors, if their type
is one of those supplied by the manufacturer. To do this, Main Unit must be uncovered, and the
steps indicated below should be followed:
1. Uncover Main Unit’s top, to gain access to the base board, and install the Sensor Interface
in a free port.
Figure B-1 Uncovered Datalog X-PRO, with the correct position of each Sensor Interface
and Communication Sigfox Module
2.
Remove approximately 1-in. (2.5 mm) of the cable mantle and strip approximately 0.2-in.
(5 mm) off the edge of each conductor.
Figure B-2 Sensor Wires Cut-ted.
www.omicroning.co March 2020
44
