Figure 5-2 Cutted Sensor Wires.
3.
Next, unscrew the cap of the cable gland from the external terminal box to allow
the sensor cable to enter it.
4.
Insert the ends of the sensor into the external terminal Box. Depending on the
thickness of the cable, select the correct rubber bushing of 5 mm or 7.4 mm, both are
supplied.
5.
Unscrew the necessary terminals, and then insert the uncovered wires in their
corresponding lines. To facilitate this task, each sensor end should be tinned or connected
to a crimp terminal. To know in which order each end must be connected refer to Sensors
connection Guide in
Appendix C.
www.omicroning.co March 2020
24