In Service Mode, the in-built Wi-Fi® module generates a local Wi-Fi® network (whose SSID is the
prefix “
IoTDevice
_”, followed by Main Unit’s factory ID; for example, “
IoTDevice_bcddc212345
”),
to which any device suited for internet navigation (such as a smartphone, or a PC) can connect.
Only after engaging to said network,
a page with the IP address: 192.168.4.1
(whose interface is
shown below), can be accessed: there, a configuration menu will allow all setups. It is possible to
access the indicated page through any internet browser.
Figure 6-3 Datalog X-PRO home configuration page
This screen,
nominated from now on as Home Page
, directs to forms where the device
administrator can specify parameters relative to the wireless communication networks to which
the device being configured will be connected.
To quit this mode, briefly place a magnet near the Main Unit 1 time.
6.2.2 Send Data
The configured publication time for each sensor will naturally limit the data transmissions
executed by
Datalog X-PRO
. However
, the device may be forced to send its readings after briefly
placing a magnet near the Main Unit 2 times.
LED Indicator will flash green only to show that the device is configuring its Communications
Module, or sending data.
6.2.3 Sleep/Off
The device can access Sleep/Off mode after
briefly placing a magnet near the Main Unit 8 times.
In this state, the device stops reading and sending data; which minimizes battery consumption.
www.omicroning.co March 2020
28
