Omcan MX-IT-0060-M, Инструкция по эксплуатации

Страница: 18 / 28

18
Maintenance
removed ensuring they fit well in the pulley grooves; the belts Pos.3 must be pulled over the cross member
in Pos.6 then inserted in pulley grooves Pos.5 and Pos.7.
• Adjust the tension of the belts in accordance with the instructions of the reference manufacturer.
IMPORTANT! To ensure the best performance of the machine and longer service life of the belts it is
crucial to replace all drive belts, not just some.
REPLACING AND ADJUSTING THE BOWL GUIDE ROLLERS AND THEIR MOUNTS
Look at Figure 19, each of the two bowl roller sets comprises an idle roller Pos.1 and a mount Pos.2; their
function is to counteract the force of the spiral whose force would otherwise deform the bowl. Replace the roller
Pos.1, provided by Omcan with the bearings (Pos.3) every time when excessively worn or unserviceable:
• Undo the screws Pos.4 and washers to remove the complete unit.
• Undo the screws Pos.5; Be careful not to drop the roller Pos.1 with the pin Pos.6 and not to lose the
washers Pos.7 and rings Pos.8; then grip the whole assembly and secure it at the mount Pos.2.
• Use a plastic hammer and a hard punch on the pin Pos.6 to get it out of the bearing Pos.3.
• Insert the new roller Pos.1 with bearing Pos.3 on the mount Pos.2 so that the hole matches with the holes
Pos.9 of the mount Pos.2.
• Insert the pin Pos.6 as far as possible in the holes Pos.9 of the mount and the centre hole of the roller
(place the shims Pos.8 between bearing Pos.3 and sides of the support Pos.2), then press down with a
hard plastic hammer; tighten the screws, Pos.5 at the ends of the pin Pos.6 with washers Pos.7.
• Reassemble the group in the
machine, screwing but not tightening
the screws Pos.4 and its washers,
in the threaded holes of the column
after passing them through the slots
Pos.10 of the mount Pos.2.
• The bowl not being perfectly
cylindrical, the roller Pos.1 must be
placed so that it touches the wall
of the bowl at the point where it is
closest to the roller itself; to do this
move the mount Pos.2 along the
slots Pos.10, then, once you find the
right position, lock it by tightening the
screws, Pos.4.
• Check that the distance between
support Pos.2 and bowl is not more
than 4mm, this is vital to minimize
the risk of gripping, dragging or
crushing between the roller Pos.1
and bowl; If you are unable to comply
with the aforementioned maximum
distance do not use the machine
and immediately contact the Omcan
company.