Omcan MX-IT-0060-M, Инструкция по эксплуатации

Страница: 14 / 28

14
Operation
Maintenance
that was in place at the time of stopping. If in the middle of a cycle you press the emergency button (Pos.8),
the machine will stop and the timer will return to its initial values.
6. During the mix cycle is possible to reverse the direction of rotation of the bowl with the selector Pos.6; this
can be useful, for example, to “mix in” any “unblended” flour in the dough remaining on the bottom of the
bowl.
IMPORTANT! The direction of rotation of spiral and bowl during normal kneading cycle must be anti-
clockwise (viewed from above). If needed, you can reverse the direction of rotation of the bowl for
the time strictly necessary. However, as soon as possible return to the normal direction of rotation
to prevent possible, even serious damages due to abnormal stress (mechanical overload on the
transmission and overheating of the motor windings).
7. Once the cycle is over, lift the cover and pull the dough out. To facilitate the operation it is possible to rotate
the bowl by pressing the button in (Pos.7) so as to bring the dough in the best position for the operator;
please note that if you release the button, the bowl stops.
8. If you want to stop the current cycle, just press button in (Pos.5); the machine stops, but the timer keeps
the elapsed time stored. To restart the machine, press the same START/speed button that was enabled at
the time of stopping. So, the kneading cycle will pick up where it left off. After pressing the button (Pos.5)
wait until the spiral stops completely (a few seconds) before lifting the cover. In normal conditions do not
stop the machine neither by lifting the cover, nor by pressing the emergency button (Pos.8.)
9. When finished with the machine, always turn the main switch, to position OFF - O; in lengthy stationary
periods, a thorough cleaning of the machine would be advisable.
PLEASE NOTE!
Except where otherwise stated, maintenance should be strictly done after:
• Pressing the emergency stop button.
• Turning the main switch on O - OFF.
• Disconnecting the plug from the power supply (the disconnected plug must remain visible so that one can
check by eye that the machine is unplugged) so that nobody else can accidentally start the machine or any