Omcan MX-IT-0060-M, Инструкция по эксплуатации

Страница: 17 / 28

17
Maintenance
DRIVE BELTS TO THE BOWL
To carry out the operations described in this paragraph and in the
relevant sub-paragraphs, always wear at least safety gloves, safety
shoes with reinforced toe and a helmet. Look at Figure 16, to access
the belts simply remove the guard in Pos.1 secured with six screws
Pos.2 on each side of the stand. At the end of the works, fit the
covers Pos.1 back on and secure with the original hardware.
ADJUSTMENT OF THE TENSION OF THE BOWL
DRIVE BELTS
Look at Figure 17:
• Turn the knob in Pos.2 to adjust the tension of the belts in Pos.1.
• To adjust the tension of the belts in Pos.3: Turn the knob in Pos.4.
Adjust the tension of the belts in accordance with the instructions of the reference manufacturer.
IMPORTANT! If you adjust the tension of the belts in Pos.1, it may be necessary to also readjust the
tension of the belts Pos.3, and vice versa. Always check the correct tension of both.
REPLACING THE BOWL DRIVE BELTS
Look at Figure 18 - To replace the drive belts
to the bowl:
• Release both belts Pos.1 and 3 with
knobs Pos.2 and 4.
• The belts in Pos.1 can be easily pulled
out from the bottom.
• To pull the belts Pos.3 out: pull them out
of the grooves on pulley Pos. 5; pull them
above the cross member Pos. 6 carrying
the mounts of the front caster; and finally
take them (Pos.3) completely out.
• Fit the new belts in the place of those you