Omcan MX-IT-0060-M, Инструкция по эксплуатации

Страница: 15 / 28

15
Maintenance
of its parts.
Before removing any cover or guard, and disable any safety, take appropriate measures so that others are not
exposed to any risks (i.e. cordon off the operations area with chains or white-red striped ribbons, hang warning
signs and boards and/ or written information warning people the of the risks); reassemble the protections and
fasten them with the fixings provided and reactivate the safety devices when the reasons for their removal have
been resolved. Any non-compliance with this manual and / or improper use, or inconsistency with the expected
use of the machine causing direct or indirect damage to people, animals, things, will be a full responsibility of
the reference person.
PERIOD MAINTENANCE AND CHECK-UP
Before any operations, make sure to implement the safety measures described previously.
• Perform accurate cleaning of the mixer at the end of each day or work shift.
• At the beginning of each day or shift, check all guards and safeties.
ADJUSTMENT OF THE TENSION AND REPLACEMENT OF THE DRIVE BELT
Always have a set of fl at or star screw drivers available before starting any maintenance Ideally procure
yourself also a set of hex plug wrench (Allen) and a set of hexagonal keys. IMPORTANT! A belt that is too tight
is likely to wear out quickly; if, instead, it is too loose it will not perform as expected and will not transfer any
drive. If the belt tension is not correct, its performance and service life will be drastically reduced. The concept
for determining whether a belt is worn out depends on the brand and the diameter of the pulleys, as well as
the length of the belts themselves. This manual contains the instructions of the manufacturer of the belts
installed by Omcan on the new mixer. However, the mixer can be equipped with any other belts from different
manufacturers, provided they are equivalent or superior in terms of features, performance and durability; In
this case, the supplier and/or installer will have to provide detailed instructions on how to properly adjust their
tension. Here we provide instructions on how to change the tension of the drive belts the spiral and the bowl.
For the procedure on how to check if the tension is correct, please consult the instructions provided by the
supplier/ manufacturer.
DRIVE BELTS TO THE SPIRAL
Wear anti abrasion gloves and
foot protection with reinforced
toe. Please look at Figure 12:
Remove the head cover (Pos.1)
to access the belt housing if
you need to adjust the tension;
Remove the Pos.3 to replace
the belts. The Pos.1 is secured
by 4 screws, Pos.2; The item in
Pos.3 is secured by 3 screws
(Pos.4). At the end of the
works, make sure to bring all