Olympus VISERA OTV-S7V, Инструкция по эксплуатации, Страница: 32 / 216

26
Chapter 3 Installation and Connection
VISERA VIDEO SYSTEM CENTER OTV-S7V
3.1 Installation
• Do not obstruct the ventilation grills with ancillary equipment,
etc. If the OTV-S7V is not cooled properly, it may be
damaged.
• Do not place any equipment other than the VISERA BF
processor MAJ-1236 on top of the OTV-S7V; equipment
damage can result.
• Place the OTV-S7V on a stable, level surface. Failure to do
so may cause the equipment to fall.
3.2 Connection to a light source
Connect the OTV-S7V to a light source as shown in Figure 3.1 using light control
cable MAJ-944.
Figure 3.1
• Use light control cable MAJ-944 which is a standard
accessory of the OTV-S7V. Other cables cannot ensure
optimum performance of the automatic brightness control
function.
• An isolation transformer is not required for the light source’s
power supply. If a light source is connected to an isolation
transformer, the demand may exceed the capacity of the
transformer.
• When using light sources with filters in combination with rigid
endoscopes, refer to the light source’s instruction manual.
Light control
terminal
OTV-S7V
Light control cable (MAJ-944)
CLV-S40/S30
Light control
terminal