Ohmart Vega W-4510, Техническое руководство по аппаратному обеспечению

Страница: 148 / 162

Appendix I: Parameter blocks
W-4510 Weigh Scale Technical Reference Manual 131
Table 15: Screen 520 OR 521 Frequency input block (continued)
Item# Parameter Name Parameter Description
32 LOW SAMPLE INPUT Enter actual value of Low Process sample collected for Standardize and
Calibrate Low procedures
33 HIGH SAMPLE INPUT Enter actual value of High Process sample collected for Calibrate High a
procedure
34 LOW OUTPUT Indicates time remaining during Low data collection and shows Cal. Check
value when data collection complete
35 HIGH OUTPUT Indicates time remaining during High data collection and shows Cal. Check
value when data collection complete
36 DURATION TYPE Enter 1=timed, 2=Start/Stop, 3=tach pulses, 4=tach/10, and 5=tach/100
37 DURATION Enter 1 to 65535 seconds, tach pulses, tach pulses/10, or tach pulses/100.
No entry needed for STDZ
38 CALIBRATE LOW
DATE Date that current standardize or calibrate low was performed
39 STDZ/CAL. LOW
AVERAGE COUNTS Raw count average from data collection during most recent Standardize or
Cal. Low procedure
40 CAL. HIGH AVERAGE
COUNTS Raw count average from data collection during most recent Calibrate High
procedure
41 ALARM LIMIT Enter 0 to 65535% of change from last standardize that should cause an
alarm. Enter 0 to turn off alarm function
42 TOTALIZER Accumulated total weight over the duration of the most recent Cal. High
data collection. Use for Cal High on bulk total
43 TOTALIZER SCALING Converts Rate data to a total. Rate divides by this factor before adding into
total
44 STDZ HISTORY #1
DATE Date of Stdz. or Cal Low before current
45 STDZ HISTORY #1
COUNTS Standardize counts for that date
46 STDZ HISTORY #2
DATE Date of Stdz. or Cal Low before History 1
47 STDZ HISTORY #2
COUNTS Standardize counts for that date
48 STDZ HISTORY #3
DATE Date of Stdz. or Cal Low before History 2
49 STDZ HISTORY #3
COUNTS Standardize counts for that date