OHAUS 7000 Series, Руководство по обслуживанию

Страница: 83 / 107

APPENDIX B COMMUNICATIONS
7000 Series T72XW Indicators Service ManualB-13 Ohaus Corporation www.ohaus.com
B-16 Commands and Responses MT-SICS Level 1
The following commands of MT-SICS level 1 are available:
SR Send weight value on weight change (Send and Repeat)
T Tare
TA Set or inquiry of preset tare value
TAC Clear tare value
TI Tare Immediately
B.16.1 SR
– SEND WEIGHT VALUE ON WEIGHT CHANGE (SEND AND REPEAT)
Command: SR_Value_Unit
SR
Response: S_S_ _ _ _ _ 105.1_lb Current stable weight.
S_D_ _ _ _ _ 106.7_lb Dynamic weight value.
S_S_ _ _ _ _ 124.3_lb Next stable weight value.
Response: S_I Command understood, not executable at present.
Response: S_L Command understood, invalid parameter.
Response: S_+ Terminal in overload range.
Response: S_- Terminal in underload range.
Example
Command: SR_0.50_kg Send the current stable weight value followed by every load
change > 0.50 kg.
Response: S_S_ _ _ _ _100.00_kg Scale stable.
S_D_ _ _ _ _115.23_kg More than 0.50 kg loaded.
S_S_ _ _ _ _200.00_kg Scale stable again.
Comments
Command to send the current stable weight once then continuously after every weight change
greater or equal to the “value” a non-stable (dynamic) value followed by the next stable
value. If no preset value is included, the weight change must be at least 12.5% of the last
stable weight value an a minimum of 30d.
SR is overwritten and cancelled by the commands S, SI, SIR, @ and hardware break.