Ofs Obeya, Руководство по сборке

Страница: 32 / 44

32 ofs.com imagine a place® 800.521.5381 Assembly instructions
Obeya assembly instructions
1. Attach the worksurface beam to post mounting brackets of the wall structure using
(2) 5/16-18 x 1 3/4" hex head bolts at each end of the extrusion. Reference beam & top rail
attachment sheet as needed.
2. Run electrical jumpers and install duplex receptacle if applicable at this time. Reference
duplex beam attachment sheet.
3. The worksurface beam cladding panels need to be installed before the worksurface
mounting brackets. See cladding installation sheet for reference.
4. Assemble the worksurface mounting brackets to the beam by placing the rectangle nuts into
the rectangle cutout in the top of the beam then slide the bracket assembly into place approx.
6" from each end of the worksurface and evenly spacing the remaining brackets for 84" and
126" tops.
5. Secure the worksurface brackets by tightening the #8-32 screws.
6. Attach the worksurface by setting it onto the mounting plates and centering it in the width of the
wall opening and the depth of the beam thickness and securing it with (8) # 12x1" wood screws
from the bottom side of each bracket.
#8-32 x 3/4"
FH screw
Note: when using surface mount power supplies
secure the power cord to the underneath side of the
worksurface where the cord exits the top of the beam
Note:
if not complete, assemble the worksurface
mounting brackets by attaching two rectangle nuts
to the bottom side of the mounting plate using (4)
#8-32 x 3/4" FH screws through the c'sunk holes in the
mount plate
Rectangle nut
Mounting plate
Worksurface
Wall structure
assembly: posts
& beams
Worksurface
beam
Worksurface mounting bracket
Cladding panel
Note: Face cladding removed for clarity
Table wall worksurface assembly