Octel Overture 250, Руководство пользователя

Страница: 13 / 55

2-2 Peripheral Equipment
101–1386–001 Edition 2
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ
Table 2-1. Cable Requirements.
ÁÁÁÁÁÁÁÁÁÁÁ
Á ÁÁÁÁÁÁÁÁÁ Á
ÁÁÁÁÁÁÁÁÁÁÁ
Server
ÁÁÁÁÁÁÁÁÁÁÁ
Á ÁÁÁÁÁÁÁÁÁ Á
ÁÁÁÁÁÁÁÁÁÁÁ
Required Cable
ÁÁÁÁÁÁÁÁÁÁÁ
Á
ÁÁÁÁÁÁÁÁÁ Á
ÁÁÁÁÁÁÁÁÁÁÁ
Octel Overture 250
Octel Overture 350
ÁÁÁÁÁÁÁÁÁÁÁ
Á
ÁÁÁÁÁÁÁÁÁ Á
ÁÁÁÁÁÁÁÁÁÁÁ
P/N 057–1335–000
P/N 057–1174–000
If you are setting up a terminal more than 50 feet from the server you must use a modem,
refer to Chapter 4 for details.
If you are setting up a terminal other than the one supplied by Octel, you might have
different cable requirements; refer to the manufacturer’s manual supplied with the
terminal.
Connecting the Terminal to the Server
To connect the terminal to the server, do the following:
1. If the terminal has not been unpacked, carefully remove it from the container.
Caution!
Do not use sharp instruments to unpack the
terminal. Sensitive components might be
damaged.
Save all packing materials, in case the terminal must be reshipped or relocated. For
specific instructions about unpacking the terminal, refer to the manufacturer’s manual
supplied with the terminal.
2. Place the terminal on a sturdy table or desk within 50 feet of the server.
3. Make sure the power switch is off.
4. Connect the keyboard to the terminal, according to the installation instructions that
came with your terminal.
5. Plug the terminal cable into the terminal connector on the back of the terminal,
according to the installation instructions that came with your terminal.
6. Open the server cabinet. The door is in the front of the 250 and at the rear of the 350.
Only certified service engineers should open
the back of the Octel Overture 350 cabinet to
connect the terminal cable. This cabinet
contains high voltages and could cause
personal injury.
Warning!