Oce CS7075, Руководство пользователя

Страница: 82 / 182

3-26 Using the Media Tables
Using the Media
Tables
The media tables are designed specifically to handle rigid media
for this printer. When the printer was installed by an authorized
service provider, the installer should have assembled and leveled
both tables to the printer (after leveling the printer). If a second
set of tables was purchased, the installer should have assembled
and leveled them as well. The printer platen and tables should lie
in the same horizontal plane to ensure smooth and accurate
media advance.
Before using the tables, check the following:
◆
The input table, at the rear of the printer, has a reflector that
is located under the media sensor and pinch roller adjust-
ment lever when the table is in operating position. If not, the
wrong (output) table may be installed.
◆
After leveling, the jam nuts on each of the tables’ leveling
feet are tightened to prevent them from moving up or down.
◆
The stabilizer bars (and clamps for the second table if used)
are securely fastened to the tables and bracket below the
printer platen. This is especially important when printing on
heavy media.
You can quickly convert the printer from sheet-fed to roll-fed
operation by unclamping the stabilizer bars from the bracket at
the bottom of the platen. If the jam nuts on the leveling feet are
tight, the table can be moved where necessary and reattached to
the printer without releveling. Similarly, the clamps for the sec-
ond set of tables also can be disconnected and reconnected
easily.
Fig. 3-11. Media tables