Oce CS7075, Руководство пользователя

Страница: 17 / 182

Important Operating Notes 1-5
◆
If the height of sheet-fed media exceeds 0.25 inches (6.35
mm), you must prepare the printer as follows before print-
ing:
◆
Raise the head height
◆
Raise the right-side louver assembly
◆
Install the left-side light-blocking mat
The printer detects when the media thickness is equal to or
exceeds 0.25 inches, and prompts you to perform these
steps. See “Loading Rigid Media” on page 3-27 for instruc-
tions.
◆
The Media Wizard stores a set of operational parameters for
predefined and user-defined media types. When you load a
new media type, select an existing Media Wizard set, or cre-
ate a custom set. Media Wizard parameter sets can be
selected at any time from the control panel. (See “Media
Wizard” on page 3-41 for details.)
◆
Enable AutoTune during long periods of unattended print-
ing. AutoTune runs AutoJet at user-defined intervals to
ensure that all jets are either working or substituted with
working jets. (See “AutoTune” on page 4-4 for instructions.)
◆
Wear cotton gloves when loading media to prevent finger-
prints that could show after printing.
◆
DO NOT rest or store a media roll on end, or you could
cause edge creases that could strike the printheads during
printing.
◆
DO NOT clean the printhead surfaces with a dry cloth or
paper towel of any kind. Use only a lint-free (Class 100 clean-
room) cloth, such as those supplied with the printer, moist-
ened with Océ IJC700 UV Print Head Flush.
◆
DO NOT reprint over any output that has not completely
cured. The rubber pinch rollers could be damaged by wet
ink. If ink does get onto the pinch rollers, clean them with a
minimal amount of isopropyl alcohol and dry them thor-
oughly before printing.
◆
DO NOT set heavy objects on the power cord or printer
cable; do not bend the cables or force them into contorted
positions.
◆
DO NOT place heavy objects anywhere on the printer.