Oce CS7075, Руководство пользователя

Страница: 50 / 182

2-12 Menu
◆
Supply Out Detection (CS7100) — reports when the supply
spool stops rotating, indicating that there is no more media.
This setting is also available on the CS7075 when the
Supply
Tension option is set to idle.
MEDIA WIZARD
◆
Platen Vacuum Control — turns on the vacuum fans, then
allows you to raise or lower the fan speed. Raise the speed if
the media is rising off the platen, lower the speed if the
media is buckling or wrinkling. Turn off the vacuum for light-
weight media such as paper or fabrics.
MEDIA WIZARD
◆
Printing Delay — slows throughput (media advance speed)
to allow the media to cool between passes, preventing curl-
ing of rigid media.
MEDIA WIZARD
◆
Media Out Sensor — enables you to disable the media out
sensor if it is malfunctioning, or enable it after it has been
replaced.
◆
Gutter Settings — determines the appearance of the top and
side gutters:
◆
Top Gutters — allows you to turn On or Off the gutter
data at the top edge of the print, which shows the job
name, ink, media, date and time printed, print mode,
lamps setting, printer, embedded software version, plus
write-in blanks for other data.
◆
Side Gutters — sets the side gutter pattern to Narrow ,
Medium , or Wide sizes, or turns them Of f . Side gutter
patterns help keep the inkjets open by firing ink through
them in a pattern outside the printed image area.
◆
Margin Settings
◆
Space Between Prints (roll-fed) — sets the blank space
between print jobs, between 0 and 10 inches (25 cm).
◆
Right and Left Margin — sets the amount of blank space
for the right and left margins, between 0.25 and 5
inches (6-127 mm) for roll-fed media, and between 0
and 5 inches (0-127 mm) for cut-sheed media.
When you set the right and left margins to zero (edge-
to-edge printing on cut-sheet media), the printer
prompts you for an
Overprint value. This is the distance
beyond the edge of the media to print, to help avoid a
blank strip if the sheet is slightly skewed, not perfectly
rectangular, or other error is present. Apply tape to the
platen at the edge of the media to catch the overprinted
ink. For further information on edge-to-edge printing,
see “Edge-to-Edge Printing” on page 3-35.
◆
Leading Margin — defines the margin on the leading
edge of cut-sheet media.