Oce CS7075, Руководство пользователя

Страница: 139 / 182

Set the Printhead Height 5-11
Set the Printhead
Height
The height of the printheads above the media is key to optimal
print quality and printer operation. When printing with the
wide range of media thicknesses supported bythe printer, it is
important to set the head height appropriately. Raising the head
height too far will increase the amount of ink overspray. Lower-
ing the head height too far may result in less overspray, but will
increase the chance that the printheads will strike the media.
For best results, use the supplied gauge to set the head height
above the media loaded on the printer. The gauge sets the print-
heads 0.085 inches above the loaded media (0.070 inches
between the protective frame on the carriage and the media).
1. Load the media you want to calibrate.
For instructions, see “Loading Roll-Fed Media” on page 3-14
or “Loading Rigid Media” on page 3-27.
2. On the Front Page screen, press the

(Menu) key to enter
the menu system.
3. From the control panel menu, press the

key to highlight
Printer Settings.
4. Press the

(Menu In) key.
5. From the Settings menu, press the

key repeatedly until
Head Height is highlighted.
6. Press the

(Menu In) key.
The carriage moves out over the platen.
7. Place the gauge next to the carriage.
You may insert the gauge from the sides or the front of the
carriage. Note that you will be measuring to the bottom of
Fig. 5-6. Head Height Gauge