Oce ColorWave 650, Руководство пользователя

Страница: 44 / 336

Finish a job in Roll-to-Roll mode
Introduction
When your print job is ready, you finish your job with the following actions:
• Cut your print
• Remove the roll
• Set the printer back in Roll-to-Sheet mode (if necessary)
This section describes the above mentioned actions
Note:
Avoid touching the printed surface with your bare hands.
Cut your print
1.
Go to the 'Queue' on the 'Printer operator panel'.
2.
Press the 'Pause & cut' button to cut your print and finish the roll-to-roll job.
Remove the roll
#
Remarks Action Step
Hold the trailing edge of
your print while you press
the manual feed button.
When the roll does not ro-
tate anymore, your print is
tightly wound. 1
Chapter 2 - Get to know the printing system 44
Finish a job in Roll-to-Roll mode