Oce ColorStream, Руководство пользователя

Страница: 455 / 524

Removing the smoothing rollers
Caution:
Observe the safety directives in the ‘Replacing the smoothing rollers — overview’ on page
454 section.
To Remove the Smoothing Rollers
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button. 1.
On the operator panel, select the following menus and elements:
■
'Replace consumables' -> 'Replace smoothing roller' menu
■
'Select smoothing roller': 'Upper and lower' or 'Upper only' or 'Lower only'
In the event of extremely varied wear of the smoothing rollers or only one-
sided surface defects, only the defective smoothing roller has to be replaced.
■
Click the 'Next' button.
2.
Click the 'OK' button to start smoothing roller replacement.
The replacement of the smoothing roller is being prepared. The developer
stations are swiveled off.
Information on the icons displayed on the operator panel under 'Steps': see
‘Explanation of icons’ on page 134 .
3.
Caution
Wait until preparation is complete:
The doors must not be opened before the relevant message is displayed on the
operator panel.
On the right-hand side of the
printing system:
Unlock the sliding door of the
smoothing module and slide it
downwards. 4.
Chapter 9 - Replacing Expendables 455
Removing the smoothing rollers