Oce ColorStream, Руководство пользователя

Страница: 142 / 524

After printing has stopped, switch the printing system back
to 'Ready'
Introduction
A print stop may be caused by the following:
■
The 'Stop' button was pressed on the operator panel or on an additional operator
panel.
■
The printing system was stopped by an error message.
■
The controller has run out of data.
If the 'Stop' button has been pressed
#
Proceed as follows:
Click the 'Ready' button.
The print operation is continued without any impairment to print or fusing
quality. The temperature of the fuser station decreases in stages in the case of
longer standby times. For this reason, the fuser station may first have to be re-
heated to its operating temperature. Depending on the type of paper, this may
take up to 30 seconds. 1.
If the Printing System was Stopped by an Error Message
#
Proceed as follows:
Correct the cause of the print stop as specified in the error message (see also
‘Processing messages on the operator panel ’ on page 475 ).
1.
Click the 'Ready' button.
Printing operation is restarted. 2.
If the Controller Has Run Out of Print Data
#
Note
If the printing system controller no longer has any print data, the printing
system stays in 'Ready' status and continues printing automatically any print
data that arrives.
Chapter 6 - Operating the Printing System 142
After printing has stopped, switch the printing system back to 'Ready'