Oce Arizona 550 GT, Руководство пользователя

Страница: 121 / 263

How to Unload and Cut Media
Introduction
This section explains all of the actions associated with how to cut and unload media when
there is still some media left on the supply roll.
Note:
If the media supply roll is empty, simply remove the empty supply shaft and the take-
up shaft. Then replace the roll of media from the take-up position with a new roll and
put the shaft into the supply position. Then you can use the empty core from the supply
position as the take-up shaft.
Unload Media Summary
The following actions are associated with unloading media:
■
A) Move the Media to Cut Position
■
B) Cut the Media
■
C) Remove Media from Take-up Shaft in Printer or Remove Take-up Shaft
■
D) Remove Supply Shaft From Printer
■
E) Remove Media Roll Or Empty Core From Media Shaft
When to do
This procedures details the actions required to unload media when there is still some
media left on the supply shaft. When the supply shaft is empty there is no need to cut or
rewind the media.
Required tool
■
5mm hex key
A: Move the Media to Cut Position
1.
Use the right foot pedal to advance the media so that the area where you want to perform
the cut is positioned over the media cut guide (if you advance too far you can rewind it
with the left foot pedal).
Chapter 6 - How to Operate the Roll Media Option 121
How to Unload and Cut Media