NXP Semiconductors
FXTH87E
FXTH87E, Family of Tire Pressure Monitor Sensors
FXTH87ERM
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2019. All rights reserved.
Reference manual
Rev. 5.0 — 4 February 2019
115 / 183
to enable the LF input depending on the application requirements. The SENS[1:0] bits
in the LFCTL1 register allows the user to select one of two input sensitivity thresholds
which determines the signal level required before the input carrier will be detected. The
sensitivity setting is used during carrier detection but does not affect reception after
the carrier has been detected. When the CARMOD bit is cleared, after a carrier with
sufficient amplitude, frequency and duration has been detected the output stage of the
amplifier is turned on to allow data reception.
14.5 LFR data mode states
The modes of operation the LFR state machine will sequence as shown in
Figure 27
.
14.6 Carrier detect
Carrier detection includes a check for a certain number of edges on a signal that is
greater than the input sensitivity threshold. During the check for carrier edges, only the
1 kHz low frequency oscillator (LFO) clock source is running so power consumption
remains very low.
During carrier detection the incoming signal is amplified and passed through a sensitivity
threshold comparator. The SENS[1:0] bits in the LFCTL1 register selects two levels
of sensitivity and determines the signal amplitude that is needed to allow edges to be
seen at the output of the sensitivity threshold comparator. When a carrier is above this
threshold, a block is powered on and validates the carrier. This frequency and duration
check function can be disabled by clearing the VALEN bit. If VALEN is set, the block
checks for the carrier duration and the carrier frequency. The time needed to validate
a carrier is programmed by the LFCDTM register. The carrier frequency should be
125 kHz. If the signal above the threshold is not within the frequency range or not present
during enough time, then the carrier will not be validated and the validation block will turn
off.
If no carrier signal is validated within the on time of the LFR, the state machine returns
to the off state and the alternating cycle of on time and off time continues. Carrier edge
counts start at zero when a new on time begins.
In the data mode (CARMOD = 0), if the required number of carrier edges are detected
before the end of the ON time, the LFR will remain ON to complete the reception of a
message telegram.
In the carrier detect mode (CARMOD = 1) there is no need to enable other LFR circuitry
to evaluate any other message components after the required number of carrier edges
are detected. One or several consecutive carriers can be validated by this process
before the LFCDF flag is set. The LFCC control bits are used to program the number of
consecutive ON times where a complete carrier validation is needed before interrupting
the MCU. In this case, the LFCDF flag is set and, provided the LFCDIE interrupt enable
is also set, an interrupt is issued to wake the MCU. In carrier detect mode, the LFCDIE
control bit should always be set because the intended purpose of the carrier detect mode
is to wake the MCU when a carrier is detected. When LFCDF is set, the LFR waits until it
is cleared before it continues the alternating cycle of on time and off time, starting with an
off time.
In data mode, when a carrier is detected the averaging filter is powered on and the
LFR continues to the next state to look for the rest of a message telegram; and the LFR
module will search for valid SYNC word (with length programmed through the SYNC
bits in the LFCTL3 register depending on preamble type). If the external LF field is not
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from