Northern Meditec Crius V6, Руководство оператора

Страница: 93 / 182

93 / 182
2. Press the start key to start the system, in the beginning the LED on probe flashes, probably
about 10 seconds later turn to normally green.
3. AG module defaults to standby mode, when connected AG module,the screen will display
【
AG is sleeping
】
.
4. Click
【
Menu
】
hot key->
【
System Setup
】
->
【
CO2 module
】；【
Operating Mode
】
select
【
Measure
】
,the screen display
【
AG is starting
】
.
5. After finish the preheat the module into full precision measurement state.
NOTE

IRMA probe is not designed to be used in contact with the patient
；

When connected the IRMA probe to the patient circuit, IRMA probe must avoid direct
contact with the patient's body
；

No matter for any reason need to use the IRMA probe to contact with the patient's
body directly, must use an insulating material between the IRMA probe and body.
7.3.2 Checking before using
Before connecting the breathing circuit of IRMA Airway adapter to the patient, be sure to perform
the following operations
：
1. Ensure that the you have finished all related operations in Chapter "7.3.1 Installation"
；
2. Connect the airway adapter to patient circuit, should observe the gas readings and
waveforms display on ventilator interface
；
3. After installed the IRMA probe on the IRMA airway adapter, do tightness check for the
patient circuit.
7.3.3 Affectingfactors of monitoring