Northern Meditec Crius V6, Руководство оператора

Страница: 119 / 182

119 / 182
10.6.24 PRToo Low
1. Connect a test lung to the ventilator and start ventilation.
2. Connect the SPO2 test module. StandBy state.Select the [Menu]
→
[Factory Setting],
input password (112358)
→
[SPO2 Module] to set SPO2 Type].
3. Set the PR low alarm limit to be greater than the current PR.
4. Verify that the [PR Too Low] alarm is activated.
WARNING

Do not rely exclusively on the nurse call system for alarm notification. Remember that
the most reliable alarm notification combines audible and visual alarm indications with
the patient’s clinical condition.

Use the specified nurse call cable when connecting with the hospital’s nurse call system
through the nurse call connection port. Failure to do so may burn the machine and
produce electric shock hazard.

Inspect the ventilator alarm signals periodically when using the nurse call function.
10.7 When an Alarm Occurs
When an alarm occurs, do as follows:
1.
Check the patient’s condition.
2. Determine the alarming parameter or alarm category.
3. Identify the alarm source.
4. Take proper actions to eliminate the alarm condition.
5. Make sure the alarm condition is corrected.
For details about how to troubleshoot alarms, refer to 10.12 Alarm information table.
WARNING

To prevent possible patient injury when alarms are active, ensure that the patient
receives adequate ventilation. Identify and remove the cause of the alarms. Readjust
the alarm limits only when they are inappropriately set for the current conditions.
CAUTION

Contact the Customer Service Department if the alarm persists without obvious cause.