Nordson VersaBlue VA, Руководство пользователя

Страница: 251 / 272

Control Panel P/N 207023 and P/N 207850 (First Generation)
B‐3
P/N 213828_11
2014 Nordson Corporation
VersaBlue_PPA
Control Panel does not Function
1
+5V LED
1)
LINK LED
2)
ACT LED
3)
Problem Possible cause Corrective action
1. Does not start.
Control panel dark or
fault indications upon
startup Fuse (1) defective (+5V LED
1)
not
lit)
Check voltage supply
Memory board (CompactFlash) not
in place Insert as described in section
Replacing Memory Board
2. Date/time incorrect Insert or replace battery and set date
and time
3. Control panel dark or
bright Background lighting / contrast
misadjusted
Use to adjust
4. Control Panel does
not Function Hardware defective
Control panel dirty *) Clean as described in section
Maintenance / External Cleaning /
Control Panel
5. No EtherNet
connection Wrong/invalid IPC IP address set Correct the IP address on the control
panel
Refer to the section
Operation, Operation
via the IPC Webserver
Incorrect EtherNet cable plugged in The LINK LED
2)
is lit when connected
properly
The ACT LED
3)
is lit when data is
transferred properly (flashes during
transmission)
Missing/defective cables or
components Check connecting cable between
IPC, EtherNet switch and
coprocessor. Connect as shown in
the system plan, if necessary.
*) The software checks the surface of the control panel during startup and
indicates dirt or defects with an X. Fingers or notepaper would also be
recognized as a "fault," stopping initialization until the fault is remedied.