Nordson VersaBlue VA, Руководство пользователя

Страница: 207 / 272

Repair
7‐3
P/N 213828_11
2014 Nordson Corporation
VersaBlue_PPA
Replacing Memory Board
ATTENTION: The memory board may be replaced only when the melter is
switched off.
NOTE: When the memory board is changed, the melter returns to its original
state upon delivery. All of the set parameters are lost, if they were not saved
as a recipe on an external PC.
1 4
5 2
3
Fig. 7‐3
1 Memory board CompactFlash
2 Eject button for memory board
3 Indication lamps (LEDs)
4 Not in use
5 Not in use
1. Make a note of the software configuration code.
2. If there are pressure sensors, make a note of the pressure sensor
assignment.
3. Save and download the recipe.
Refer to section Operation, Upload and Download of Customer Recipes .
4. Switch the melter off with the main switch.
5. Refer to Detaching Control Panel .
6. Press the eject button and remove the old memory board.
7. Carefully slide in the new memory board until the eject button pops out
again.
8. Reconnect any cables that may have come loose from the control panel.
9. Attach the control panel.
10. Switch on the melter again.
11. Enter software configuration code.
Refer to section Operation, Melter Configuration .
12. Check assignment of each pressure sensor on the control panel; set up
and calibrate if necessary.
13. Upload the recipe, load it on the control panel and save it under its own
name.