Nordson VersaBlue VA, Руководство пользователя

Страница: 51 / 272

Outputs
Inputs
Installation
3‐11
P/N 213828_11
2014 Nordson Corporation
VersaBlue_PPA
Interface Assignment
Interface Standard I/O
General Notes
To conform with a European standard regarding electro-magnetic
compatibility (EMC), only shielded cable may be connected. The shield
must
be connected to ground in compliance with the standard regarding
electromagnetic compatibility.
Inductive loads (e.g. solenoid valves) connected to the melter must be
equipped with a protective device (e.g. recovery diode) that disables the
inductive voltage generated when an inductive load is switched off.
The permitted voltage deviation is ±10%.
In the field bus-based control modes Field bus and Dual (option Field bus
communication ), the melter cannot be controlled via this interface.
NOTE: * optional
Digital inputs
Pin Input Function
1 * 24 V
DC
Internal (melter)
2 * 0 V
DC
External (customer's)
NOTE: Customer connects his reference potential here, if 24 V
DC
is provided by
customer.
3
0 V
24 V
Rising edge: Heaters ON (main contactor closes)
0 V
24 V Falling edge: Heaters OFF (main contactor opens)
4 24 V: All motors ON (collective enable)
0 V: All motors OFF
5 24 V: Enable motor 1
0 V: No Motor 1 enable
6 24 V: Enable motor 2
0 V: No Motor 2 enable
Pin 7/8 not assigned
9
0 V
24 V Rising edge: Enter Standby
0 V
24 V Falling edge: Exit Standby
10
0 V
24 V Rising edge: Key-to-line mode (for all motors)
0 V
24 V Falling edge: Manual mode (for all motors)
Continued ...