6
Rear Panel Connectors
OPERATION
Power up
To power up the T-Box™ 2, connect the DC Power connector to the back of the T-Box™ 2, and plug the other
end into the mains supply. Wait a few seconds for the system to initialise; you may see the power button blink
on and off during this time.
Finally press the power button on the front panel. The T-Box™ 2 will take about 20 seconds to completely
power up. Once completely powered the display will show two Select Task screens. This gives you the ability
to work with two transducers at a time or to have 2 different views of the same transducer. In terms of screens
and operation they are both identical.
If you need to turn off your T-Box™ 2 tap the power icon in the bottom left corner and then select ‘Shut Down’
IMPORTANT: TO TURN ON AND OFF THE T-BOX™ 2 USE EITHER THE POWER BUTTON ON THE
FRONT PANEL OR THE POWER ICON IN THE T-BOX™ SOFTWARE
TIP: The touch screen allows you to easily navigate through the T-Box™ 2 screens. A quick tap on
an icon will take you to that screen and for some screen’s sliding your finger up and down will
scroll the items on the screen.
TIP: The Settings Icon is always in the top left corner and this will return you to the Select
Task Screen
If you need to turn off your T-Box™ 2 tap the power icon in the bottom left corner
and then select ‘Shut
Down’
Port 2 AnB (Transducer)
Port 2 Ancillary
Power Connector
Port 1 AnB
(Transducer)
Port 1 Ancillary
RS232
