NorAM 65ET T4 FINAL, Руководство оператора

Страница: 98 / 194

NORAM 65ET GRADER
4-20
Every 50 Hours or Weekly
1
4
Lubrication and Maintenance - Grader Components
Moldboard and Circle Turn - Clean / Lubricate
Grease and clean moldboard slide bars
(1)
and circle turn
(2)
with graphite paint.
Wheel Lug Nuts - Check
Check to ensure wheel lug nuts
(1)
are installed and
tight on all wheels. Use a torque wrench to verify the
front and rear wheel lug nuts are torqued to 440–475
N•m (325–350 lb-ft).
Hoses and Clamps - Inspect / Replace
Inspect all hoses for wear and damage, including, cracking, softness, loose clamps, damaged end
fittings, cut or ballooning outer coverings, exposed wires, and crushed or kinked areas.
If wear and damage is present, replace.
Pressurized fluid can penetrate body tissue and result in serious injury or
death. Leaks can be invisible. keep away from any suspected leak.
Relieve pressure in the hydraulic system before searching for leaks,
disconnecting hoses, or performing any other work on the system. If you
must pressurize the system to find a suspected leak, use an object such
as a piece of wood or cardboard rather than your hands. When loosening
a fitting where some residual pressure may exist, slowly loosen the fitting
until oil begins to leak. Wait for leaking to stop before disconnecting the
fitting. Fluid injected under the skin must be removed immediately by a
surgeon familiar with this type of injury.
2
1