NorAM 65ET T4 FINAL, Руководство оператора

Страница: 63 / 194

NORAM 65ET GRADER
3-9
Op
eration
3
Driving the Machine
Steering
The basic method of steering the motor grader is through the front steering wheels. The turning
radius can be reduced by using the front wheel lean and frame articulation.
Whenever negotiating a sharp turn, reduce the speed before entering the turn.
Front Wheel Lean
NOTICE:
Remove front axle wheel lean lock pin
(1)
before
tilting (leaning) wheels. DO NOT operate machine with
wheel lean lock pin installed.
Slow machine speed before leaning the wheels into a turn to decrease the radius and create a more
aggressive bite, particularly on soft or slippery surfaces. After the turn is complete, straighten the
wheels before resuming normal speed.
When crossing a steep incline tilt the wheels into the incline to increase traction.
When making heavy cuts or moving heavy loads that tend to push the machine to the side, the wheels
can be leaned into the load to counteract the pushing effect. Lean wheels in the direction of the
discharge.
To tilt wheels to the left move the Wheel Lean Control
Lever
(1)
forward. To tilt wheels to the right move control
lever rearward.
DO NOT use wheel lean when traveling at high speeds. Wheel lean at high
speed may result in erratic machine motion.
Know the limits of the machine. Driving across slopes can cause rollover.
1