NorAM 65ET T4 FINAL, Руководство оператора

Страница: 135 / 194

NORAM 65ET GRADER
5-9
Lubrication and Maintenan
ce - Cummins Tier 4 Final
5
Every 500 Hours or Every 6 Months
Engine (Lubricating) Oil and Filters - Change
1. Change oil filter
(1)
when the engine oil is changed.
NOTE:
The o-ring can stick on the filter head. Make
sure it is removed before installing the new filter.
2. Remove plug
(2)
on bottom of the engine oil pan and
drain oil into a suitable container. Dispose of waste oil
according to federal, state and local regulations.
3. Clean area around oil filter. Remove oil filter using
filter wrench. Make sure sealing ring is removed and
clean filter mounting surface.
4. Apply a thin film of new oil to new filter sealing ring.
5. Install new filter and tighten until sealing ring
contacts mounting surface. Tighten an additional 3/4
turn.
NOTICE:
DO NOT over-tighten. Over-tightening can damage the filter.
6. Install plug in engine oil pan. Torque to 17 ft-lb (24 Nm).
7. Remove oil fill cap
(3)
and add 9.5 L (10 qt) of oil.
8. Start engine and allow to idle for 3 to 5 minutes to
circulate oil. Turn off engine and wait 15 minutes.
NOTICE:
Engine oil pressure MUST be indicated on the
gauge within 15 seconds after starting. If oil pressure is
NOT registered within 15 seconds, shut off engine
immediately to avoid engine damage. Confirm that the
correct oil level is in the oil pan.
9. Check oil level using dipstick. If necessary, add oil
until level is between minimum and maximum marks
on dipstick. Check filter and drain plug for leakage.
1
2
3