NorAM 65ET T4 FINAL, Руководство оператора

Страница: 62 / 194

1
NORAM 65ET GRADER
3-8
Operatio
n
3
Driving the Machine
D
RIVING THE
M
ACHINE
• Never coast machine with transmission in neutral.
• Select proper gear before starting up or down a hill. for downhill use the same gear or lower as
would be used to go uphill.
• DO NOT attempt to decelerate on grades by shifting. reduce engine speed and apply service
brakes.
• Reduce speed before turning or applying brakes.
• Always sit in driver's seat, with seat belt fastened, while starting or driving motor grader.
• Shift into forward or reverse at low idle speed. High engine speed shifting may cause sudden
movement, resulting in operator injury.
• Downshift or upshift one gear at a time. Wait until engine speed stabilizes before selecting next
gear.
• Obey all traffic regulations and be aware of other traffic. Ensure motor grader is equipped with
lights and signage according to all federal, state and local regulations. obey flagmen.
• When roading motor grader always carry moldboard within the wheel width and as high as pos-
sible.
• Install lock pins in front and rear implements when traveling between job sites.
• When using motor grader to tow, use only the designated rear drawbar.
Power Brakes
Two brake pedals
(1)
, linked together, are located on
each side of the front console.
To stop the machine, depress either of the pedals. If the
Inching Control is deactivated, the transmission will
disengage when either brake pedal is depressed. If the
Inching Control is activated, the transmission will
continue to drive the machine. The motor grader will
slow and stop as applied braking pressure overcomes the
torque converter.
NOTE:
Greater effort will be required to stop the
machine with the inching control activated.
NOTE:
With the inching control deactivated, movement may be jerky as the transmission
disconnects and reconnects.
Observe the following precautions when driving the motor grader:
1