NorAM 65ET T4 FINAL, Руководство оператора

Страница: 66 / 194

1
NORAM 65ET GRADER
3-12
Operatio
n
3
Moldboard and Implement Operation
The Implement Control Lever
(1)
raises and lowers the
selected implement. The front of the motor grader may be
equipped with a scarifier or blade, and the rear of the
machine may be equipped with a ripper.
NOTE:
DO NOT engage the ground with the front
and rear implements at the same time.
If the machine is equipped with the optional ripper and
scarifier, the Implement Switch
(2)
located on the top of
the front console, selects the front or rear implement. To
operate the front implement, switch should be rocked
rearward. To operate the rear implement, switch should
be rocked forward.
Before lowering an implement into the ground, start the
motor grader moving in either first or second gear. Move
the throttle control lever forward so engine speed is at
least 3/4 of maximum.
Move implement control lever
(1)
forward to lower selected implement (front or rear). Release lever to
return to NEUTRAL position when implement is at desired depth. Pull lever rearward to raise
implement.
NOTICE:
Never back drag scarifier or ripper teeth. Damage to the tool bar will result.
When the motor grader is equipped with the float option, it has the capability to float the implement
and moldboard height. To place implement in float mode, push Implement Control Lever forward.
The lever is held in place by a detent. To release detent, pull lever rearward to NEURAL.
Always raise implement completely and insert lock pin when transporting
machine between job sites. Unintended lowering of implement at high speed may
result in abrupt stopping of machine and cause operator injury.
1
2