NorAM 65ET T4 FINAL, Руководство оператора

Страница: 59 / 194

NORAM 65ET GRADER
3-5
Op
eration
3
Rollover Protective Structure (ROPS)
Starting Engine
1. Insert key in the Ignition Switch and turn clockwise to “START”. Hold in position until engine
starts or for a maximum of 30 seconds, whichever occurs first, and release to the “RUN” position.
2. If engine does not start within 30 seconds, wait two minutes to allow starter to cool before
repeating.
3. After engine starts, allow coolant to warm and lubricant to circulate for 3-5 minutes. Monitor all
warning lights and gauge readings to ensure normal operation.
NOTE:
If engine does not start after three attempts, check fuel supply system. The absence of
blue or white smoke indicates no fuel is being delivered.
NOTICE:
After starting engine, check brakes, steering and implement controls before moving.
Engine Block Heater (Optional)
An optional 110 volt electric engine block heater may be installed. The block heater warms the engine
fluids to reduce drag on internal components for easier starting.
Connect a grounded extension cord to the heater plug
first. Then connect the extension cord to the grounded
electrical outlet.
While heaters may be operated continuously, they will last much longer if they are operated only as
long as necessary to permit easy engine starting.
Disconnect the extension cord from the grounded electrical outlet first and then
from the heater before starting the engine. Inspect the heater wires periodically
for broken or frayed wires and/or wire coverings. If wires and/or coverings are
broken or frayed, do not use the heater.
To avoid shocks, or other injuries, never use an ungrounded or inadequate
extension cord. Always use a grounded 3-wire extension cord with a 3-wire plug
rated for at least a 15 amp load and protected by a suitable fuse or circuit
breaker.