D-F0472 NP-2411/3411 Product Specifications Ver. 1.00
39
13) [Underline SET/RESET] « ESC – n »
Code: [1B]h + [2D]h + n
*[00
≤
n
≤
02]h
SET/RESET Underline.
* Underline is valid to all characters except for area skipped by [Horizontal Tab].
Also, underline is not valid to 90º clockwise rotated character.
* This command is not valid when Kanji mode.
* Underline is verified with “n” value as shown bellow.
n(hex) Type
00 RESET
underline
01
SET one dot underline
02
SET two dot underline
*Default value of “n” is [00]h.
14) [1/6 inch Line Feed Pitch] « ESC 2 »
Code: [1B]h + [32]h
Sets one line feed pitch to 1/6 inch.
15) [Smallest Line Feed Setting] « ESC 3 n »
Code: [1B]h + [33]h + n
*[00
≤
n
≤
FF]h
Sets line feed pitch to n/203 inch.
* Although setting under value of character’s height, it will execute line feed for the
amount of character’s height.
* When setting n = [00]h, does not feed even if pressing FEED switch. Except, feeds
when using presenter or bezel sensor “B” function.
* Default value of “n” is [22]h.
16) [Data Input Control] « ESC = n »
Code: [1B]h + [3D]h + n
*[00
≤
n
≤
FF]h
Selects device that data input from the host is valid.
* Each bit of “n” indicates below;
value
bit function
0 1
0 Printer
INVALID
VALID
1 Undefined
2 Undefined
3 Undefined
4 Undefined
5 Undefined
6 Undefined
7 Undefined
* When printer is not selected, all receipt data are deleted until the printer is selected
by this command.
* When printer is not selected, depending on printer operation it may become busy
status.
* Default value of “n” is [01]h.
17) [Printer Initialization] « ESC @ »
Code: [1B] h + [40] h
Clears data stored in the print line buffer and initializes (default status) each setting.
* Does not clear data stored in the internal receive buffer.
* Does not re-read memory switch.
* Stores in receive buffer and executes sequentially.
