D-F0472 NP-2411/3411 Product Specifications Ver.1.00
PRECAUTION
Read Carefully Before Using the Product
Handling the product in a wrong way may decline its performance and also damage the product. Read the notes below before handling the product.
[Failures]
1.
Static discharge prevention or body grounding must be made for installation and removal of the product to prevent damage of sensor parts etc. Connect
it to the earth ground for ESD measures.
2.
Avoid excessive force to the input terminals.
3.
Avoid printing with no paper loaded. It can damage thermal head and also shorten its life-time.
4.
DO NOT open the front cover while printing and/or cutter operation. It may damage thermal head and cutter.
5.
DO NOT pull out the paper with the front cover closed.
6.
DO NOT block the paper outlet while print operation. Also, DO NOT grab the paper while print operation.
7.
DO NOT scrabble or give impact to thermal head with sharp edge object or any hard materials, which may damage the heat elements.
8.
This product is NOT protected against dust or dirt. If used in harsh environment like at dusty place, the thermal head may get damaged or paper feed
may not run properly.
9.
When cooling the product with a fan, keep the air exhaust slit away from the printer’s paper exit area so that dust or dirt may not get in the thermal head.
10. This product is equipped with an infra-red reflection sensor. The product must be installed where there is NO direct sun light/infra-red light coming in, as
otherwise, the sensor would not function properly. The sensor function may be affected also by the pre-printed paper if the pre-printed color appears on
the side of paper roll.
11. Use both hands when holding the product in order to prevent from dropping.
12. The product should NOT be installed where it could be exposed to static electricity easily, strong vibration, electromagnetic field, corrosive gas, rain, fog
and direct sunlight.
[Safety]
1.
Turn OFF the power before connecting or removing connectors. When disconnecting, handle with the connector body and DO NOT pull out by a cable.
2. The product is NOT protected from water or dew drop. DO NOT put water to the product nor handle it with wet hand because it may damage the
product due to short circuit or heat or fire.
3.
In order to prevent excessive current, add an electrolytic capacitor and a fuse(refer to power supply specifications for details) to external 24V power line.
4.
Plug off the printer when the product is not in use for a long time.
5.
DO NOT disassemble or modify the product.
6.
In case of disposal, follow the regulations or rules of the local authorities.
7.
Use power supply in conformity with LPS standard.
