D-F0472 NP-2411/3411 Product Specifications Ver. 1.00
33
5.2 Printer Driver
Applicable to various OS.
Windows 2000 / Windows XP / Windows CE 5.0 / Linux (only sample)
5.3 Command Details
1) [Horizontal Tab] « HT »
Code: [09]h
Print position moves to the next horizontal tab position.
*Horizontal tab is set by [Horizontal Tab Position Setting] command.
* Default of [Horizontal Tab] is every 8
th
character (9 digit,17 digit,
･･
,41digit) in font A.
(2 inch model is until 33rd digit)
*If the next [Horizontal Tab] is not set, this command is disregarded.
2) [Print and Line Feed] « LF »
Code: [0A]h
Prints out data inside print line buffer and line feeds based on preset line feed quantity.
3) [Page Feed] « FF »
Code: [OC]h
Prints out data inside print line buffer and page feeds based on preset page length to
the next top of the page.
*Default of page length is [42]h (66 lines).
*Unable to use at the same time of [Print start/finish Setting] command.
4) [Carriage Return] « CR »
Code: [0D]h
*This command is disregarded.
5) [Software Reset] « DC1 »
Code: [11]h
Restarts firmware as same process when turning the power ON.
* Since this command will be stored in internal reception input buffer and executes
sequentially, timing of command receipt and execution will be different.
* If during cutter movement, software reset will be activated after auto-cutter finishes driving.
6) [Barcode Termination Change] « ESC RS c n »
Code: [1B]h + [1E]h + [63] + n
*[n = 00, 80]h
Change terminator of [Barcode print] command with “n”.
* “n” is indicated as follows;
n(hex) termination
00 [00]h
80 [FF]h
* Default of “n” is [00]h
7) [Character Right Space Quantity] « ESC SP n »
Code: [1B]h + [20]h + n
* [00
≤
n
≤
20]h
Sets right SPACE quantity of character by dot. (1/203 inch unit)
* Right SPACE is reflected with zoom when double width zoom mode.
* Default of “n” is [00]h.
