D-F0472 NP-2411/3411 Product Specifications Ver. 1.00
40
18) [Back Feed] «ESC B n»
Code: [1B]h + [42]h + n
*[00
≤
n
≤
FF]h
This command is for forwarding paper in reverse direction.
* Set forwarding length in “n” Dot line. In case of set [00]h, no forwarding.
* You should set this command once only due to avoid paper jam, and then forward
paper in right direction.
* Backlash may let paper not put properly.
* In case there is print data on buffer of Print Line buffer, it should be backfeed after printing.
* Tip of paper should not be exceeding the limit of back feed. (Use [n
≤
34]h)
* When conducting back-feed after selecting and executing “black mark sensor” [n1 =
01h] in [Paper-out Signal Detector Selection], make sure to designate feeding amount
so that black mark will be stopped right in front of paper-out sensor by back feed.
19) [“n” line Page Length Setting] « ESC C n »
Code: [1B]h + [43]h + n
*[01
≤
n
≤
FF]h
Sets a page length with “n” lines under current line feed pitch.
* Position when setting will be top of the page.
* Page length will not change even if changing line feed pitch after setting.
* Default value of “n” is [42]h. (66 lines)
* When executing printer initialization, top of the page will also be initialized.
* DO NOT set when using [Print start/finish Setting] command.
20) [Horizontal Tab Position Setting] « ESC D n1 n2 --- NUL »
Code: [1B]h + [44]h + n1 + n2 + --- + [00]h
* [00
≤
n
≤
FF]h
Sets horizontal tab position.
* “n” indicates the digits from the head to the tab position.
In this case, it shall be [n = tab position – 1].
* Although tab position is set at the point of (character width x “n”) from head of the line,
in this case, character width includes right SPACE amount of the character and when
double width zoom is set, width becomes double of ordinary character.
* Enables to set max. 32 tab positions and settings exceeding this will be disregarded.
* « ESC D NUL » clears all set tab positions. After tab setting is cleared, tab movement
by [Horizontal Tab] command will be invalid.
* Default of [Horizontal Tab] is every 8
th
character (9 digit,17 digit,
･･
,41digit) in font A.
(2 inch model is until 33rd digit)
21) [Enhanced Print SET/RESET] « ESC E n »
Code: [1B]h + [45]h + n
*[00
≤
n
≤
FF]h
SET/RESET Enhanced Print.
* Only LSB (least significant bit “b0”) is available to “n”.
“b0” has the following meaning.
b0 Value
0
RESET enhanced print
1
SET enhanced print
* Bold print and double strike print result in the same with this printer.
* When executing enhanced print, print result may be deformed.
* Default value of “n” is [00]h.
