D-F0472 NP-2411/3411 Product Specifications Ver. 1.00
23
(2) How to set each switch
Please set memory switch from MS1-1 to MS1-2
→
…
→
MS1-8
→
MS2-1
→
…
→
MS2-8
sequentially.
* Pushing FEED switch with ALARM LED (red) lit, it switches as ON setting and the
contents will be printed out.
* Pushing FEED switch with ALARM LED (red) lights off, it switches as OFF setting and
the contents will printed out.
Setting finishes after 16 times repetition of the above operation and prints out list of set
contents right before automatically entering software reset movement.
* In case you want to cancel setting, open up head cover and push FEED switch once,
then you can cancel setting after closing down head cover.
(Finished setting contents until that cancellation will remain and rest of unfinished
setting will be all set as OFF.)
4.1.4 Memory Switch setting by on-line command
Memory switch setting (or changing) by on-line command can be conducted by the host
following the below command after setting a roll paper and maintaining the printer ready.
Printer prints out new setting contents and activates software reset before new setting
becomes effective.
1) Setting command
[Printing and Setting of Memory Switch] «GS M n d1 d2»
It is possible to set or print, setting content of memory switch MS1 and MS2.
*Refer to “4.1.1~2 Memory switch” for each MS content and note.
*Refer to “5.3 46) [Printing and Setting of Memory Switch]” for memory switch setting by
command.
4.1.5 Self-diagnostic print
(1) Checking by self-diagnostic print
* Function of control circuit board
* Version for control F/W
* Setting statuses of memory switch
* Movement of paper end sensor
(2) Start and finish of self-diagnostic print
Turn ON the power with pressing FEED switch and release a finger from the FEED
switch after initialization response from the printer mechanism. Finishes after printing
out prescribed printing patterns. During self-diagnostic printing, printer is in off-line
status.
4.1.6 Paper Sensor
There is a sensor as paper detector, attached to paper path of the main body and
detects a complete paper-out condition. The printer will transmit paper-end status and
stop printing as soon as detection of paper out.
Since it is not detectable, do NOT use a roll paper that is glued to the core at the end
of the paper. Replace to a new paper as soon as detection of paper out.